FTR USB UART IC Datasheet Version Clearance No.: FTDI# •. •. Neither the whole nor any part of the information contained in, or the product. FTDI FTRL: available from 8 distributors. Explore Integrated Circuits ( ICs) on Octopart: the fastest source for datasheets, pricing, specs and. FTRL Datasheet, FT FTDI USB to Serial UART IC Datasheet, buy FTRL USB to Serial UART IC.
|Published (Last):||14 May 2018|
|PDF File Size:||11.94 Mb|
|ePub File Size:||4.24 Mb|
|Price:||Free* [*Free Regsitration Required]|
With bus powered applications, the following should be noted: A suitable range of Ferrite Beads is available from Steward www.
It has separate enables on both the transmitter and receiver. The SP is specified to transmit and receive data at a rate of up to 5 Mbaud.
The solder reflow profile for both packages is described in Section 9. Input 12MHz Oscillator Cell.
FT232RL USB to UART Breakout Board
The above mecha nical drawing shows the SSOP package. This can be done using a link to switch the VCC supply.
When a non -standard baud rate is required simply pass the required baud rate value to the driver as normal, and the FTDI driver will calculate the required divisor, and set the baud rate. Support for bus powered, self powered, and high-power bus powered USB configurations. The FTR will fail to operate when the internal oscillator has been disabled, but no external oscillator has been connected. In accordance with the USB 2. Failure to do this may cause some USB host or hub controllers to power up erratically.
Receive data LED drive: The FT-X series is the latest device family offering reduced power and pin count with additional features such as battery charge detection, while the Dahasheet solution offers faster interfacing. The pins are on a 0. The FTR supports synchronous bit bang mode.
There are many suitable level converter devices available. Please refer to the following applications note on how to do this: Please refer to Section 3 for the package option pin-out and signal descriptions.
The recommended solder reflow profile for both package options is shown in Ft322r 9. It has been designed to operate efficiently with a USB host controller by using as little as possible of the total USB bandwidth available.
Adjustable receive buffer timeout. Remember me on this computer. In-built support for event characters and line break condition. FIFO receive and transmit buffers for high data throughput. Preheat – Temperature Min T s Min.
UART signal inversion option. RS is a multi-drop network; so many devices can communicate with each other over a two wire cable interface.
FTRL USB to UART Breakout Board
Tray packing, pcs per tray QFN only For example: Y our s tatutory rights are not affec ted. This package is nominally 5. In addition, asynchronous and synchronous bit bang interface modes are available. This number cannot be reprogrammed.
Some external logic has the ability to power itself down into a low current state by monitoring the PWREN signal. Puts the device into IC test mode. This is followed by the revision number. A useful feature of these devices is the SHDN pin which can be used to power down the device to a low quiescent current during USB suspend mode. Packing codes for xxxx is: New CBUS bit bang mode option.
Values are shown for both a completely Pb free datssheet process i.